I bought this unit second hand, with a set of mounting clamps as pictured. They won't grip the small flange available, and Oliveri claim that this is an under-mount sink. I don't want it undermounted, and don't think the design wants to be undermounted. So, to use these clamps, here is what to do:. Cut down the body of the clamp and the bolt by about 5mm or 2-3 threads. I ended up with a range of sizes and most worked. If you start with 12, lose a couple to error, then you still have enough. Bend the legs away from the biting teeth - they are going to press inside the curve of the flange and balance the torque produced by screwing down.
Hard parts - getting a hole through the flange, driving the bolt through the hole without the thread stripping, getting the whole job done in a way that lets you seal with silicone and put the clamps on to hold it in place. Getting the clamps down is sufficiently difficult that I chose not to undo them to silicone under the lip of the sink.
No comments:
Post a Comment
This is your chance to be heard, really heard! Finally the world will take you seriously. So do try to post something worthwhile.